Do you possess room that might use a ceiling fan Installing a ceiling fan yourself is relatively easy, if you are basically replacing a light fixture that is already in the proper location woodworking plans. All of the wiring you need is already around so the only thing is to exchange the existing workbox with one that is made for the weight of a ceiling fan. It would be very deadly if you do not exchange your current workbox to something that can take on the added weight of the ceiling fan. Before you perform anything, read the instructions for your fan very carefully and make sure that you have the needed tools.

If you intend to get the fan on the cathedral ceiling, you will have to get an extension to ensure the fan wont be so high up. As soon as you have every little thing ready to go, the very first thing you should do is make sure that the breaker is turned off so no power goes to the light fixture. The moment you remove the light fixture, check to see if the current workbox can cope with the increased weight. Generally they aren't designed for a ceiling fan, so you will have to include more support. Including support to the workbox is not that tough if you have access to the light fixture from the attic.

All you want to do, is nail a 2x4 within the ceiling rafters, so it touches the top of the workbox. Ensure the 2x4 is attached in its place, and then attach the box to the wood. If everything is done properly, the excess weight of the fan will now be totally supported by the wood and the screws. In cases where you are incapable to do it from the attic or you have basically no attic, you will have to include a cross bracing in your ceiling. This is harder to do, and probably not as protected in the end, but will have to do with no attic access.

At this point, after constructing the fan according to the instructions, you are prepared to place the new fan. The issue is to store the fan while connecting the wiring. It depends upon the kind of fan you have, quite a few come with a bracket with a J hook while others have a clinging frame. For many fans the wall switch will turn it on or off, as the chain will control the speeds. If you need a light kit together with your fan, they can be manged by either chain or wall switch woodworking plans.

Next, just stick to the wiring directions, usually as easy as connecting the two black wires, the two white wires, and the two ground wires. Now all you will need to do is finish assembling the fan according to the guidelines, by attaching the fan blades woodworking plans. Immediately after you attach the blades, the only thing left is to flip the breaker back on to find out if you did it right.